Bathtub Installation in Mt Prospect, IL

We've been doing bathroom remodeling in Mt Prospect, IL for over 20 years as a family-owned business. That means we've done enough bathtub installations to know where corners get cut and how to avoid every one of them. We pull permits when required, we don't farm your job out, and you'll talk to the same person from estimate to final walkthrough.

A lot of homeowners come to us after another contractor left them with a tub that wobbles, a surround that's already growing mold, or a drain that sits a quarter inch too high. We fix those too, but we'd rather you call us first. As a full bathroom remodeler, we can handle the tile, the fixtures, and the plumbing in one visit instead of juggling three separate trades.

Mt Prospect, IL gets real winters. Freeze-thaw cycles hit older homes hard, and bathrooms on exterior walls or above uninsulated crawl spaces are especially vulnerable. We see failed caulk lines, cracked surrounds, and rotted subfloors in homes across the NW Suburbs every spring. When we do a bathtub installation, we check the insulation behind the surround wall and flag any moisture damage before it spreads. Getting that right up front saves you from a much bigger repair two winters from now.

Alcove Tubs, Freestanding Tubs, and Everything Between

The most common bathtub installation we do in Mt Prospect, IL is the standard alcove tub swap. The old tub comes out, the new one drops in, and we retile the surround. It's a one-to-two day job for most bathrooms and it makes a dramatic difference.

Freestanding models take a bit more planning. They need a floor-mounted filler or a wall-mounted spout that reaches far enough, and the drain location has to line up with your existing rough plumbing or we'll reroute it. Soaking tubs, whether freestanding or built-in, also need us to verify your floor can handle the added weight when the tub is full. We check that before anything goes in.

What Proper Bathtub Installation Actually Involves

Good bathtub installation isn't just dropping a tub into an opening and caulking the edge. The tub has to be level and fully supported underneath, or it'll flex when you step in and crack the surround over time. We bed alcove tubs in mortar or use adjustable feet depending on the model, and we confirm solid contact across the entire base.

Waterproofing the surround is just as important as the tub itself. We use a membrane behind the tile, not just cement board, so moisture that gets past the grout has nowhere to go except back out. That's the step most DIY installs skip, and it's why we get calls about mold two years after someone did it themselves.